scuffing

英 [ˈskʌfɪŋ]

美 [ˈskʌfɪŋ]

v.  磨损; 磨坏; 拖着脚走
scuff的现在分词

现在分词：scuffing　

柯林斯词典

• V-ERG (使)磨损;(使)磨坏
  If youscuffsomething or if itscuffs, you mark the surface by scraping it against other things or by scraping other things against it.
  1. Constant wheelchair use will scuff almost any floor surface...
     任何地板上经常有轮椅走动几乎都会有所磨损。
  2. Molded plastic is almost indestructible, but scuffs easily.
     注塑几乎弄不坏，但是容易磨损。
• VERB 拖着脚走
  If youscuffyour feet, you pull them along the ground as you walk.
  1. Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
     波莉既困惑又尴尬，低下头拖着脚走开了。

双语例句

• Study of monitoring on line about the gear scuffing test
  齿轮胶合试验在线监测方法研究
• She's always scuffing her shoes in the playground.
  她总是在操场上磨损鞋子。
• Research of Test on Gear Scuffing and Monitoring Technique
  齿轮胶合的试验研究及其监测技术
• Influence of Lubrication Oil on the Scuffing Resistant of Sliding Friction Pairs
  润滑油对滑动摩擦副咬死性能的影响
• The research method adopted in the paper are fo some significance to the study of gear scuffing mechanism and the study to increase the gear scuffing load carry capacity.
  本文的研究方法对齿轮胶合机理和提高齿轮胶合承载能力的研究都是有意义的。
• Effect of EP Additive Content on Scuffing Resistance to Heavy-duty Gears
  极压添加剂含量对重载齿轮抗胶合能力的影响
• The anti scuffing, friction reducing and wear resistant properties were investigated systematically on a pin on disc tester under engine oil lubrication condition.
  用销盘试验机在机械油润滑条件下对渗硫表面的抗擦伤性能，减摩及耐磨性能进行了系统研究。
• At the same time, for the power splitting differential gearbox the characteristics of compact structure, according to balanced specific sliding and flash temperature for the planet gear, the parameters of planetary gear can be optimized, gears can improved wear resistance and scuffing resistance.
  同时针对功率分流差动齿轮箱结构紧凑的特点，根据均衡齿轮的滑动率曲线和闪温曲线的研究，优化了行星轮系的齿轮参数，提高了齿轮的抗磨损、抗胶合能力。
• Analysis and Calculation of Fuzzy Reliability on Scuffing Resistance of Gear Drive
  齿轮传动抗胶合模糊可靠性分析与计算
• Numerical investigation on interaction of axial and lateral response for super-long pile The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
  轴-横向荷载作用下超长桩数值模拟为了避免划伤，轴承上的最大负荷应该总是小于其卸载负荷。