asperities

英 [æsˈpɛrɪtiz]

美 [əˈspɛrɪtiz]

n.  (尤指语言、态度)粗暴，严厉
asperity的复数

双语例句

• Numerical results reveal that the existence of single asperities can lead pressure to change drastically and film thickness to become thin in the vicinity of the asperities.
  结果表明，单粗糙峰造成接触区对应位置油膜压力剧烈变化而膜厚变薄。
• Undoubtedly, these asperities will have remarkable influence on surface friction and subsurface stress of the contact area.
  齿面粗糙峰的存在无疑会对齿面摩擦力和轮齿接触区次表面应力分布产生重大影响。
• However, at higher angle of tooth-shaped asperities and under higher normal stress, the failure model II is found, which is in first tension but final shear failure.
  在较高的法向应力下，含起伏角较高齿形节理面的非贯通节理岩体可能出现破坏模式II（先张拉后剪切破坏模式）。
• If the gouge layer is thin, contact between asperities on the rock surfaces can occur.
  如果充填物层很薄，两个岩石表面上的凸起物就有可能互相接触。
• The highest temperature of asperities is much higher than that of worn plane, which is one of the main factors in leading to stress graphitization on worn surface.
  摩擦过程中粗糙表面微凸体的最高温度远大于摩擦平面，瞬时的高温和摩擦剪切力的作用使微凸体被应力石墨化。
• Earthquake doublet in Kagoshima, Japan: rupture of asperities in a stress shadow
  日本鹿儿岛的地震对：应力影区中的凹凸体破裂
• Agglomerates of delusterant particles located near the surface of sythetic fibers cause asperities.
  消光剂颗粒集结在合成纤维表面附近，导致表面粗糙。
• Based on the interaction of asperities and upper-bound approach a mathematical model for simulation of friction phenomenon between dies and workpiece was proposed.
  本文中以刚性微凸体与可变形微凸体的相互作用模拟金属压力加工过程中模具与工件之间的摩擦过程，并用上限法分析所提出的模型。
• In this paper, a three-dimensional measuring system for surface asperities is described, in which a microcomputer is interfaced to a stylus profilometer.
  本文介绍采用触针式轮廓仪与通用微型机相连的表面三维形貌测量系统。
• The relationship between sliding friction force and contacting condition of rough surfaces was developed according to kinematics and dynamics analysis of two contacting asperities.
  从一对微凸体的接触力学和运动学分析出发，建立了非流体动力润滑条件下粗糙表面滑动摩擦阻力与粗糙表面接触状态间的关系。